Tubes and fittings  in the BioPharm range are manufactured in accordance with extra-strict quality assurance procedures.

All cold-formed BioPharm tubular products feature consistent wall thicknesses as a result of the use of fabrication-grade tubing. Once cold forming has been completed, these tubular products are resized to ensure that their ovality always falls within the prescribed tolerances.

A machined square-cut method is used to provide properly finished end facings, ensuring the most accurate, consistent orbital welds. All fittings are inspected visually, while ovality and squareness tolerances are inspected with calibrated equipment. All surface finishes are inspected with a calibrated profilometer to measure the Roughness average (Ra).

Products available in the Tri-Clover range are:

Ferrules, 90 and 45 Degree Elbows, Concentric and Eccentric Reducers, Tee's, Reducing Tees, Blanks, Clamps

Material

Stainless Steel 316L

Connections

Buttweld or Tri-Clamp Options

Surface Finish

0.8 Ra Mechanically Poished or 0.4 Ra Electropolished

Technical Information

All products from the Tri-Clover range meet BPE standards and are supplied with full material traceability certificates for each fitting